Need advise on what I should get.

General discussion about Daytime Optics.

Moderator: Michael

Need advise on what I should get.

Postby JD83 » Sat Feb 23, 2013 12:40 am

Hey Guys,

I'm in Canada so I'm restricted on the level of performance I can get here... So I'm looking at what would be the most performant unit under 1500$ I might go to 2000$ depends if its worth it... I'm currently looking at the D300m 2+MS and the Armasight NYX-14 Gen 2+. Both device are in the 1300$ range however D300m is 32 lp/mm and the Armasight 45-51 lp/mm.

Anyone with knowledge on both of those units that could hint me toward which one to lean toward? I'm not THAT fussy about resolution but I want the one with the best amplification/low light operation performance if one is better than the other that is...

I used to have some Newcon NZT-22 and I'm trying to use those as base reference resolution wise but some site advertise them being 3.5 lp/mm... Some others 35-36 and even 40... In any case I wouldn't be less inclined in a gen2 unit with lower resolution than a 400$ gen1 unit...

I want to know your take on this guys, enlighten me! :)

Best regards,

JD83
JD83
 
Posts: 2
Joined: Wed Feb 20, 2013 11:08 pm

Re: Need advise on what I should get.

Postby JD83 » Sat Feb 23, 2013 12:41 am

Else what would be the most performant exportable unit in 1500$ range if you know better than those two?
JD83
 
Posts: 2
Joined: Wed Feb 20, 2013 11:08 pm


Return to General Discussion

Who is online

Users browsing this forum: No registered users and 1 guest

cron